Sure Heat Sonoma SGR27 Natural Gas Conversion Kit - Manual (Page 5)

Installing the NG regulator
1. Remove the LP regulator from the main gas pipe
using an adjustable wrench. Located inside the
cart on bottom of grill head. (See Fig. 18)
Remaining end still connected will be removed
later.
2. Remove the LP nipple brass fitting from main gas
pipe. (See Fig. 19)
Note: For the following steps, the supplied pipe
dope needs to be applied to all indicated
fittings before the fittings are screwed in.
Pipe dope should not be used on any
flared fittings!
3. Remove the grommet in the side of the cart by
pressing in on the side with your fingers.
(See Fig. 20)
4. Attach the “T” fitting to the main gas pipe as
shown. Tighten with wrench. (See Fig. 21)
5
Fig 18
Fig 19
Fig 20
SGR27 Natural Gas Conversion Instructions
Main Gas
Pipe
Main Gas
Pipe
LP Nipple
Fig 21
Main Gas
Pipe