Sure Heat Vent-Free SCVFA - Manual (Page 10)

10
LIGHTING INSTRUCTIONS FOR REMOTE CONTROLLED SYSTEM
Model SCVFMR
AUTO-THERMOSTATIC MODE
6. To switch to Auto mode press the following buttons:
(See Fig. 16)
Set button - “AUTO” will start blinking
Set button (while “AUTO” is still blinking)
Note: After switching to Auto mode, the temperature
will start blinking. This is the temperature you
wish the room to reach.
7. To change the temperature in Auto mode press the following
buttons: (See Fig. 17)
Up button -Temperature will start blinking
(each press raises the temperature one degree)
Set button (while temperature is still blinking)
Or
Down button -Temperature will start blinking
(each press lowers the temperature one degree)
Set button (while temperature is still blinking)
The number of flames automatically adjusts to the correct
setting in order to reach the desired temperature
.
Note: After a few seconds the display returns to showing
the current room temperature.
8. To turn the unit off press the following buttons: (See Fig. 18)
On/Off button - “OFF” will start blinking
Set button (while “ON/OFF” is still blinking)
Fig 16
Set
Auto
Fig 19
Fig 17
Up button
Up button
Flames
Down button
Set
Fig 18
On/Off button
On/Off button
Set
Off
8. To switch the unit
from Fahrenheit to
Celsius press the
following buttons:
(See Fig. 19)
On/Off button -
Either “ON” or “OFF”
will start blinking.
On/Off+Up (while
“ON” or “OFF” is still
blinking)
Repeat steps to
switch back to
Fahrenheit