Sure Heat VFMO Vent-Free - Manual (Page 8)

Page 8
REMOTE CONTROL
REMOTE CONTROL
Supply voltage:
4.5V (three 1.5 V “AAA” batteries)
Ambient temperature ratings:
0 - 60°C (32 - 140°F)
Radio frequency:
315 MHz
RECEIVER:
Supply voltage:
6.0V (four 1.5 V “AA” batteries)
Ambient temperature ratings:
0 - 60°C (32 - 140°F)
Radio frequency:
315 MHz
TECHNICAL DATA
INSTALLING BATTERIES
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS:
(1) This device may not cause harmful interference, AND
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
WARNING: The transmitter and the receiver are radio frequency
appliances. If the receiver is mounted inside metallic cases,severe
loss of performances (reduction of the range of working) may result.
ATTENTION!
- Turn “OFF” main gas supply of the appliance during installation or
maintenance of the receiver.
- Place the receiver’s 3 position slider switch in the “OFF” position during
installation or maintenance.
- Turn “OFF” main gas supply of the appliance prior to removing or
reinserting the batteries in the receiver.
COMMUNICATION BETWEEN THE
REMOTE CONTROL AND THE RECEIVER
To program the transmitter to the receiver,
move the three positions slider of the
receiver in the REMOTE position and
depress the ON/OFF key of the transmitter.
The System has got an automatic learning
mode that allows the receiver to mate with
a new transmitter in the event that the
transmitter must be replaced. As soon as the
receiver receives the first correct command
from any remote control it captures the new
address and then “beeps” 3 times to confirm
the synchronization and command execution.
Side
Slider
Transmission
light
ON/OFF
Key
CHILD SAFETY LOCK-OUT FEATURE
With this function it is possible to deactivate the remote control key.
BACKUP FUNCTION
If the batteries of the Receiver are low, the
appliance can be switched on manually by
moving the 3 position slider switch on the
Receiver to the ON position.
Install four (4) “AA”
batteries into the
remote receiver
box as shown on
the left.
Install three (3)
“AAA” batteries
into the remote
control as shown
on the left.
Child safety
function ON
Child safety
function OFF
- -
+ +
- -
+