Sure Heat Tuscany CS892LP - Manual (Page 13)

Pre Operation Leak Testing
GENERAL INFORMATION
Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness
check must be performed at the installation site due to possible shifting during shipment, installation
or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for
leaks and immediately check the system if the smell of gas is detected.
BEFORE TESTING
1. Do not smoke while leak testing.
2. Extinguish all open fl ames.
3. Never leak test with an open fl ame.
4. Mix a solution of equal parts mild detergent or liquid soap and water.
TESTING
1. Turn off the burner control knobs.
2. Turn the top knob of the fuel supply cylinder counterclockwise (right to left) two (2) rotations to
open.
3. Apply the soap solution to connections of the fuel supply assembly. If no soap bubbles appear,
there is no gas leak. If bubbles form at the connections, a leak is detected. If a leak is detected,
immediately turn off the gas supply, tighten any leaking fi ttings, turn gas on, and repeat steps 1-3.
4. Turn off the knob on the fuel supply cylinder.
5. Turn on the burner control knobs for a moment to release the pressure in the hose, then turn the
control knobs back off.
6. Wash off soapy solution with cold water and towel dry.
Check all gas supply fi ttings before each use and each time the gas supply cylinder is connected to
the regulator. Have a qualifi ed service technician leak test the grill any time a part of the gas system
is replaced.
Also it is recommended to perform a leak test at least once a year whether or not the L.P. gas supply
cylinder has been disconnected.
When leak testing this appliance, make sure to test and tighten all loose connections,
including the side burner. A slight leak in the system can result in a low fl ame, or hazardous
condition. Most L.P. gas tanks now come equipped with a leak detector mechanism internal
to the tank, when gas is allowed to escape rapidly, it shuts off the gas supply. A leak may
signifi cantly reduce the gas fl ow making the grill diffi cult to light or causing low fl ames.
If you cannot stop a gas leak turn off the gas supply and call your local gas or the dealer you
purchased the appliance from. If necessary, replace the faulty part with the manufacturer’s
recommended replacement part. A slight leak could cause a fi re.
▲
! WARNING
▲
! WARNING
13