Sure Heat 2007 Amana AM33 - Manual (Page 26)

ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the
rotisserie counter clockwise to the “ HIGH” position.
Wait 5 seconds. Then press and hold the electronic
igniter button. You’ ll hear a snapping sound. If the
burner does not light in 4 seconds, turn the control
knob to OFF and wait 5 minutes before trying again.
Once lit, turn the control knob to the desired setting.
(See Fig. 55)
If the igniter does not function, the burner can be lit by
holding a lit match to the burner while the control knob
is turned counter clockwise to “ HIGH” . (See Fig. 56)
NOTE: After the first use the stainless steel around
the burner will darken. This is a normal reaction of
premium stainless steel to heat and is not a defect.
The infrared panel will also darken after initial use.
This is also a normal occurrence.
SIDE BURNER LIGHTING
Push and turn the side burner control knob to the
“ HIGH” position and immediately press and hold
the electronic igniter button. You’ ll hear a
snapping sound. It may be necessary to hold the
electronic starter button for about 4 seconds. If
the burner does not light in 4 seconds, turn the
knob to the “ OFF” position and wait 5 minutes
before trying again. Repeat above steps to light
remaining burners. (See Fig. 57)
MATCH LIGHTING OF THE BURNER
If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Keep
your face as far away from the burner as possible
and place a lit, long stem match through the
spaces in the grate to the ports of the burner.
Position the match near the burner ports and
push and turn the control knob to the “ HIGH”
position. (See Fig. 58)
Fig. 55
Fig. 56
Accessory Lighting
26
NOTE: Do Not operate the main
burners and infrared back burner at
the same time. This can cause
warping of the roll top grill hood.
Fig. 57
Fig. 58