Step 2 – Sunny Health & Fitness SF-E906 User Manual

Page 6

Text mode
Original mode

STEP 2:

a: Connect the Sensor wire (15) with Trunk line (14). Then connect the Tension Control (19）

with the Tension Wire (20). Note: Before connecting these wires, set the Tension Control (19)
to the lowest tension level ‘1’ (by turning the knob to the left until the tension level reads ‘1’).
This will insure the wires are at their longest reaching points to meet up and connect easier.

b: Insert the Handle bar post (4) into the Main frame (1), lock up with the Screw (40) and Arc
washer (56).