StarTech.com PEX2S952PW - Manual (Page 6)

Instruction Manual
3
9
J4 J4 J9 J4 J9
Serial Port 2
Pin Normal 5V 12V
1
J5 J5 J9 J5 J9
4
J7 J7 J9 J7 J9
8
J6 J6 J9 J6 J9
9
J8 J8 J9 J8 J9
Hardware Installation
1. Turn your computer off and any peripherals connected to the computer (i.e. Printers,
external hard drives, etc.). Unplug the power cable from the rear of the power
supply on the back of the computer and disconnect all peripheral devices.
2. Remove the cover from the computer case. See documentation for your computer
system for details.
3. Locate an open PCI Express slot and remove the metal cover plate on the rear of the
computer case (Refer to documentation for your computer system for details.). Note
that this card will work in PCI Express slots of additional lanes (i.e. x4, x8 or x16 slots).
4. Gently insert the card into the open PCI Express slot and fasten the bracket to the
rear of the case.
NOTE: If installing the card into a small form factor/low profile system, replacing the
pre-installed full profile bracket with the included low profile installation bracket may
be necessary.
5. Connect an LP4 Molex power connector from the computer power supply, to the
power connector on the card.
6. Place the cover back onto the computer case.