StarTech.com PCI8S950 - Manual (Page 5)

Instruction Manual 2
Packaging Contents
• 1 x PCI serial card
• 1 x Port “dongle” connector (PCI4S950 only)
• 2 x Port “dongles” + 1 ribbon cable panel (PCI8S950 only)
• 1 x Installation CD
• 1 x Instruction Manual
Installation
This section will guide you through the installation of your PCI card and the related software.
Please read through the instructions carefully and complete each step in the order listed.
Installing the Card
NOTE: Advanced computer users may wish to change the clock options on the card. Please see
“Advanced Performance Configuration” on page 4 before installing the card.
1. Make sure that your system is unplugged and you are grounded.
2. Remove the cover of your system (see your computer’s user manual for details, if necessary)
and gently turn your computer onto its side.
3. Locate an empty PCI slot (usually white in color) and remove the metal plate that covers the
rear bracket. You may need a Phillips screwdriver to perform this step. Retain this screw! You
will need it to secure the card later.
4. Gently insert the card into the empty slot, making sure it is firmly seated.
5. a) Secure the card in place using the screw you removed in Step 3.
b) If you purchased a PCI8S950 (8 port model), connect the ribbon cable panel for the second
dongle connector to the pins on the card, with the red stripe on the ribbon cable facing Pin 1
(as marked). Remove the screw and metal plate on another available slot. Secure the second
dongle connector in place with the screw.
c)If you purchased a PCI4S950 (4 port model) or PCI8S950 (8 port model), connect the port
dongle(s) provided to the port on the back of the card (and the additional dongle connector
you installed, if applicable).
6. Put your computer case back on.