StarTech.com PEXUSB3S44V - Manual (Page 5)

Instruction Manual
2
Installation
Hardware Installation
WARNING! PCI Express cards, like all computer equipment, can be severely damaged
by static electricity. Be sure that you are properly grounded before opening your
computer case or touching your card. StarTech.com recommends that you wear an
anti-static strap when installing any computer component. If an anti-static strap is
unavailable, discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds. Also be
careful to handle the card by its edges and not the gold connectors.
1. Turn your computer off and any peripherals connected to the computer (i.e. Printers,
external hard drives, etc.). Unplug the power cable from the rear of the power
supply on the back of the computer and disconnect all peripheral devices.
2. Remove the cover from the computer case. See documentation for your computer
system for details.
3. Locate an open PCI Express x4 slot and remove the metal cover plate on the rear of
the computer case (Refer to documentation for your computer system for details.).
Note that this card will work in PCI Express slots of additional lanes (i.e. x8 or x16
slots).
4. Insert the card into the open PCI Express slot and fasten the bracket to the rear of
the case.
NOTE: If installing the card into a low profile desktop system, replacing the
preinstalled standard profile bracket with the included low profile (half height)
installation bracket may be necessary.
5. Connect either an LP4 or a SATA power connection from your system power supply
to the card.
6. Place the cover back onto the computer case.
7. Insert the power cable into the socket on the power supply and reconnect all other
connectors removed in Step 1.