StarTech.com SAT32MSATM - Manual (Page 6)

Instruction Manual
3
2. Gently apply pressure to the top center of the drive until it locks into place on either
side of the SSD clip. To release the drive from the SSD clip, pull up on the top of the
clip using the leavers attached to either side of clip.
3. The mSATA drive is now installed.
System Installation
1. Open your computer case (refer to the computer case user manual for details).
2. Connect an available SATA power connector from your power supply to the SATA
power portion of the included SATA to 4-pin Power Adapter.
3. Connect the 4-Pin portion of the included SATA Power to 4-pin Power Adapter to
the 4-pin power connector on the SAT32MSATM.