StarTech.com IES81000POE - Manual (Page 6)

Instruction Manual
3
Installation
Wall-Mounting
1. Attach the wall mount brackets to the switch (one per side) using the screws
provided.
2. Depending on the mounting surface, use the appropriate hardware to mount to the
wall surface.
Hardware Installation
1. Plug one end of the power adapter into an open electrical outlet and the other into
the DC connector on the rear panel of the Network Switch. The Power LED on the
front of the Switch should now be lit.
2. Connect a network cable to port 1 on the front panel of the switch, and connect the
other end of the cable into the RJ-45 port on your upstream switch or router. The
connection speed should auto-detect and the appropriate LEDs will illuminate to
show activity.
3. Connect your PoE or non-PoE devices to the remaining ports on the switch (e.g.
computer, IP Phone, IP Camera, etc.). The switch will auto-detect connection speed
and whether PoE is required, and the appropriate LEDs will illuminate and show
activity.