Curtis Mathes CMC13003 - Manual (Page 18)

Programming the
Channels, continued
• When entering single-digit
channels, press 0 first. For
example, to select channel 8,
press 0, then 8.
• When entering three-digit
channels, press the +100
button on the remote control
first. For example, to select
channel 104, press +100, then
press 0, then 4.
2 Press MENU to display the
menu.
3 Press CH until “Setup” is
highlighted.
4 Press VOL+ to display the
Setup menu.
5 Press CH until
“Add/Erase” is highlighted.
6 If you want to:
• Add a channel: Press
VOL+ or VOL– to display
“Added.”
• Erase a channel: Press
VOL+ or VOL– to display
“Erased.”
You can still view a channel that
is not stored in memory by using
the number buttons to select the
channel directly.
Setting the Clock
To record programs while you
are away, or to use the sleep
timer, you must first set the
clock and calendar.
There are two ways to set the
clock:
Option 1, Direct: The digits for
hours and minutes are entered
directly.
Option 2, Auto: The TV’s clock is
synchornized to a time signal
sent out by the local PBS
channel.
1 With the main menu
displayed, press CH
until
“Time Set” is highlighted.
2 Press VOL+.
The Time Set menu appears.
3 Press VOL+ to activate the
“Clock Set” and “Manual”
field. (Note: Press VOL+ to
alternate between “Manual”
and “Auto”.)
Option 1: Setting the clock
directly (“Manual” Method)
1 Press the CH button to
select the “Clock” field.
2 Press VOL+ to activate the
hour digits.
3 Press CH or CH to set
the current hour.
✔ Be sure to set the correct time of
day (am or pm), which appears to
the right of the minutes.
TV O PERATION
12 C HAPTER T HREE : TV O PERATION
AA68-00951A/eng 10/26/00 8:52 AM Page 12