StarTech.com ET1110PSE - Manual (Page 7)

Instruction Manual
3
DIP Switch Setting
The ET1110PSE is provisioned through the use of a single 4‐pole DIP (Dual Inline
Package) switch located on the front panel. Setting a switch down places it in
the ON position.
Switches 1&2: provide setting auto‐negotiation (Nway) or manual forced speed of 10,
100 or 1000. Default is all OFF.
Switch 3: when ON (down), sets the forced Half Duplex for either 10Base or 100Base, or
sets Full Duplex when OFF (up).
Switch 4: is used to enable the LFP (Link Fault Pass‐Thru) function. LFP is enabled
when the switch is ON (down).
DIP Setting
ON “ “
OFF “ “
1 2 3 4
UTP/NWAY
I
G
N
O
R
E
1000/FULL
100/FULL
100/HALF
10/FULL
10/HALF
LFP ON IGNORE
1 2 3 4
ON