StarTech.com SATDOCK4U3RE - Manual (Page 9)

Instruction Manual 6
5. Setup
5-1. Auto Compare
Automatically runs the Compare HDD function after copying. OFF by default.
5-2. Button Sound
Turn audio feedback (beeping) ON/OFF. OFF by default.
5-3. Device Info
Lists information about the Source/Destination disks.
6. PC Mode
Returns the Duplicator to Docking Station mode.
7. Advance Setup
7-1. Read Error Skip
Ignore any read errors (sector or block) detected during the copying process.
Normally, read errors result in cancellation of the copying process.
7-2. Quick Erase
Quickly erase all the data on the Source hard drive.
7-3. Secure Erase
Perform the Secure Erase command on any of the connected hard drives.
7-4. System Info
Lists the current firmware version.
Duplicator (Copy) Mode
Use the “UP” and “DOWN” buttons on the duplicator dock to select the Copy HDD
mode and press the “ENT” button to confirm the selection. The duplication will begin
immediately from the Source disk to all available Destination disks. The LCD screen will
display transfer rates, progress percentage, amount of data copied and a countdown
timer to an estimated time for completion.
NOTE: As the duplicator dock creates a 1:1 copy from the Source to the Destination,
the Destination disk(s) must be of equal or greater capacity than the Source disk.
The duplication can be paused at any time by accessing the menu and selecting the
Copy HDD option again. When prompted to confirm pausing the duplication, press
the “ENT” button. When paused, to resume the duplication, select the Copy HDD
option from the main menu.