beautypg.com

Installation, Hardware installation – StarTech.com IDE3510U2GB User Manual

Page 6

background image

Instruction Manual

3

Installation

WARNING: Hard drives require careful handling, especially when being transported. If

you are not careful with your hard disk, lost data may result. Always handle your hard

drive and storage device with caution.

Hardware Installation

1. Remove the 4 thumb screws from both sides of the enclosure (8 thumb screws in

total) and remove the side panels.

2. Lay the hard drive into the drive tray and connect the IDE ribbon cable and LP4

molex power connectors to the hard drive.

3. Turn the enclosure over, or onto it’s side and use the 4 small drive screws (included)

to secure the hard drive from below.

4. Once the drive is securely mounted, replace the side panels with the thumb screws.
5. Connect the power cable a power outlet and into the rear of the enclosure. Switch

the enclosure on, by setting the switch to ‘1’.

6. Connect the USB cable from rear of the enclosure to the computer.

This manual is related to the following products: