StarTech.com UNI2510U2V - Manual (Page 6)

Instruction Manual
3
4. Place the 2.5” hard drive into the drive tray and slide it into the connector firmly. If
using an IDE hard drive, the connector is located towards the front of the drive tray,
while the SATA drive connectors are located towards the rear of the drive tray.
5. Place the top cover of the enclosure back onto the drive tray. Slide the top cover
towards the front of the enclosure and lock into place by sliding the latch on the
bottom to the lock position.
6. Connect the USB “Y” cable from the enclosure into the host computer system. Make
sure at least the Primary connector is plugged into the computer. If the drive does
not seem to get enough power, plug in the Secondary connector as well.