StarTech.com S3510BMU33B - Manual (Page 5)

Instruction Manual
2
Introduction
Packaging Contents
• 1x USB 3.0 SATA 3.5in Hard Drive Enclosure
• 1x Pack of Foam Spacers
• 1x 3ft USB 3.0 Cable
• 1x Universal Power Adapter
• 3x Power Adapter Plug (NA/UK/EU)
• 1x Instruction Manual
System Requirements
• Computer system with available USB 3.0 (5 Gbit/s) port or USB 2.0 port (480Mbps)
• 3.5” SATA Hard Drive (HDD)
• Microsoft® Windows® 2000/XP/Server 2003/Vista/Server 2008 R2/7/8/8.1 (32/64-bit),
or Apple® Mac® OS 9.x/10, or Linux®
Hardware Installation
WARNING! Hard drives and storage enclosures require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and storage device with caution. Be sure that
you are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
1. Set the enclosure on a flat surface, with the cooling fan facing downwards.
2. On the top panel, remove the two small screws at the corners. Remove the top
panel.
3. Located at the opposite end from the internal SATA connectors is a small plastic
wedge. Flip the wedge up and out of the enclosure.
4. Place the 3.5” SATA hard drive into the enclosure and then slide it into the SATA
connectors.