StarTech.com SV431DVIDDU Manual - Manual (Page 11)

Instruction Manual
7
Auto-scan ++
Automatically cycle
through active ports in
sequence every 10 seconds.
Auto-scan with
programmable
delay
+++
(= 0~9: where 1=10sec,
2=20sec…9=90sec,
0=100sec)
Auto-scan with a custom
set delay time.
Stop Auto-scan Press any key on keyboard
Terminate Auto-scan
activity.
1. The USB keyboard hotkeys allow you faster and broader control of KVM switching
operation, in addition to the front-panel buttons. If you have configured a hotkey
preceding sequence other than two consecutive scroll locks, you should change
your hotkey sequence accordingly.
2. When the binding of PC, Audio and Mic switching is enabled by the hotkey
sequence: ScrLk + ScrLk + Q, any PC, audio and mic switching are bound together.
To remove this binding, use the hotkey sequence: ScrLk +ScrLk + W
LED Information
Green LED indicates PC port status: solid green – active port; flashing green – PC
not connected;
Red LED indicates hub port control status: solid red – that PC has the control of all
hub ports.