Cabletron Systems MicroMMAC 24T MICROMMAC- - Manual (Page 32)

REQUIREMENTS/SPECIFICATIONS
2-13
.
TPIM-F3
TPIM-F3, shown in Figure 2-7, is an ST connector that supports Single
Mode fiber Optic cabling.
Figure 2-7. The TPIM-F3
Table 2-8. TPIM-F2 Specifications.
Parameter
Typical
Value
Worst Case
Worst Case
Budget Typical
Budget
Receive
Sensitivity -30.5 dBm -28.0 dBm — —
Peak Input
Power -7.6 dBm -8.2 dBm — —
Transmitter Power:
50/125
µ
m -13.0 dBm -15.0 dBm 13.0 dB 17.5 dB
62.5/125
µ
m -10.0 dBm -12.0 dBm 16.0 dB 20.5 dB
100/140
µ
m -7.0 dBm -9.0 dBm 19.0 dB 23.5 dB
Error Rate: Better than 10 -10
Table 2-9. TPIM-F3 Specifications
Parameter Typical Minimum Maximum
Transmitter
Peak Wave Length 1300 nm 1270 nm 1330 nm
Spectral Width 60 nm – 100 nm
Rise Time 3.0 nsec 2.7 nsec 5.0 nsec
TPIM-F3
LNK
RX TX