Quick start, 01 : power, 02 : sensor in connection – Source Audio Hot Hand Wah User Manual

Page 4: 03 : guitar/audio connections, Your hot hand comes with the following components

01 : Power

The ﬁrst thing you will need is power. Your Hot Hand

™

unit comes with

4 AA

batteries to get you started. The batteries will typically last about

hours. To avoid concerns about battery life, we recommend you buy a Source
Audio

9V DC

power supply (A) (see power supply note on page

for exact

requirements).

02 : SENSOR IN connection

Next, connect the supplied

EXTENSION CABLE

to the

SENSOR IN

jack (B). Later,

you’ll plug the other end into the wire that trails from the Hot Hand, but hold
off on that for now.

03 : Guitar/Audio Connections

Now, you’ll need to make the audio connections. Plug a regular ¼-inch
guitar cable from your guitar into the

GUITAR IN

jack

(C)

. Connect your amp

(or other audio device) to the

GUITAR OUT

jack, again with a regular ¼-inch

cable

(D)

Note: Plugging a cable into the input will turn the unit on, causing the

LED

to light up brieﬂy. Don’t forget to turn off the unit by unplugging this cord—
otherwise the battery will continue to drain.

Quick Start

Your Hot Hand comes with the following components.

��

��

��

��

�

��

��

��

��

��

��

��

Hot Hand Control Box

Hot Hand Motion Sensor

Hot Hand Extension

Hot Hand Arm Band

Hot Hand Rings (5 sizes)

4 AA Batteries

Carrying Case

Quick Start | 7

6 | Quick Start