Soniclean S2800 - Manual (Page 9)

The following error conditions are shown on the cleaner's display.
Display Explanation
Drnb This indicates sensors detect liquid when wash tank supposed to be empty. For
diagnosis this error, refer to section 7.3
FAIL Indicates that the operator programmed values have been lost and will need to be re-
programmed. For diagnosis this error, refer to section 7.1
HOT Indicates an excessive heat condition. For diagnosis this error, refer to section 7.5
LO Indicates a low level in the wash tank. For diagnosis this error, refer to section 7.2
OFLO Indicates that liquid has been detected in an area of the machine that should always be
dry. For diagnosis this error, refer to section 7.4
rtc Indicates the Real Time Clock (RTC) date/time in the system is considered invalid. For
diagnosis this error, refer to section 7.6
P-UP Indicates a clean process was interrupted and did not complete the full cycle. May also
relate to the way in which the machine was shut down. For diagnosis this error, refer to
section 7.7
H2OL Indicates a water leak in the system or circuit/wiring failure. For diagnosis this error,
refer to section 7.8
IP-? (MRS function only) Indicates the configuration of the machine is not known. For
diagnosis this error, refer to section 7.9
S-2800 Irrigator Operating Manual Page 5
© Soniclean Pty Ltd Version 20 March 2014