Program mode, 1 program entry points: 6.2 program parameters – Soniclean S2800 User Manual
Page 17
6. Program Mode
The parameters can be altered by entering the program mode. There are 3 ways of entry to this mode.
6.1 Program Entry Points:
6.1.1 Alternative 1 – Program at Start Up
1. Press the “PROG” key then turn on the machine.
2. Hold the “PROG” down until the machine displays “CT 10”.
3. Release the “PROG” key.
6.1.2 Alternative 2 - Program during Operation:
1. When the machine will display “- - - -“
2. Hold down the “SHIFT” key and then press the “PROG” key and hold for 3 seconds.
6.2 Program Parameters:
To program the parameters, enter program mode as desired in 6.1, then:
1. The machine will display a variety of parameters that may reconfigure.
2. Press the arrow “UP” key to increase the parameter and the arrow “DOWN” key to decrease the
parameter.
3. To accept a value press “ENTER”. The display will scroll through the parameters.
4. Refer the tables below for parameters and values.
KEY TO PROGRAMMING DISPLAY
PARAMETER
DISPLAY
UNIT
MIN
MAX
FACTORY
SETTINGS
Clean time
Ct
mins
1
99
10
Ultrasonics power level
PO
1
3
3
Clean number
Cn
0
99
10
Detergent concentration
SP
percentage
0.0
5.0
0.5
Start up de-gassing time
G1
mins
0
99
10
De-gassing time
G2
mins
0
99
2
Test time
tt
sec
0
99
30
Irrigate default
Id
0=Off
1=On
1
Irrigate rest periods
N.B. Irrigator on time is 5
secs
Ir
1 rest period
= 5 secs
5 period
(5x5 =
25 secs)
50
5
S-2800 Irrigator Operating Manual
Page 13
© 2013-2014 Soniclean Pty Ltd
Version 20
March 2014