Solberg STS Series - Manual (Page 5)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Rev: MMSTS-1147
Page 5
SOLBERG
3. Removing Tube Assembly for service/maintenance.
A. Tube will be secured in place with a high tension clamp. Remove clamp
and tube assembly will drop out of canister.
B. Tube assembly can be cleaned from dirt particulate for better flow results.
*WARNING*
Failure to comply with these instructions
may result in system contamination.
4. Securing Tube Assembly.
A. Insert tube assembly over extruded ring within casting.
B. Secure high tension clamp over tube assembly and tighten down on
extruded ring within casting. Note: Do NOT over tighten!
*WARNING*
Defective installation may cause system
contamination. Use only genuine Solberg
replacement parts.
Section D
MAINTENANCE RECOMMENDATIONS
1. Always check replacement o-rings/gaskets to insure they are seated
uniformly along the casting flange during installation. If o-rings/gaskets do not
seat properly or are damaged in some manner, contact Solberg
Manufacturing, Inc. immediately.
2. Always check inlets/outlets of casting during service for heavy particulate
buildup or collection.
3. Operate only when a proper seal exist.