Solberg SMConfigurationD(Pg.3-10,11) - Manual (Page 12)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 12
5. Removing element for service/maintenance.
A. Carefully remove retaining hex nut/ or wing-nut and washer over top plate,
and then remove element.
B. Clean sealing surfaces of housing, top plates and element end caps so
that they are free of dirt or any other particulate.
*WARNING*
Failure to comply with these instructions
may result in system or equipment
contamination.
6. Securing Element.
A. Place new or cleaned element evenly on base plate. Be sure element
seats properly on base and there is no dirt or particulate present on
sealing surfaces. With multiple element stacks place elements in line with
base element and ensure elements seat properly.
B. Place top plate on element by centering on tap bolt.
C. Secure washer and hex nut to top plate and tap bolt. Element must be
tightly secured. Note: Do NOT over tighten!
*WARNING*
Defective installation may cause system or
pump contamination. Use only genuine
Solberg replacement parts.
Figure C.5.3: Element with
pre-filter and gaskets. Figure C.5.2: Element
sitting in housing base. Figure C.5.1: Element
top plate removal.