Solberg CompactF(Pg.3-4,5) - Manual (Page 11)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 11
5. Securing canister top to canister base.
A. Make sure all surfaces are free from dust and other particulate.
B. Place weather hood over housing base and element. Feed threaded rod
into corresponding bolt hole and tighten. Note: Do NOT over tighten!
6. Equipment Startup.
A. Be sure to read the instructions on installation or element replacement as
listed above before starting equipment.
*WARNING*
If at any time the operator is unable to verify
the integrity of the element or any housing
feature, the factory or a regional representative
should be contacted prior to start-up.
B. Please check the listed steps prior to startup.
1. Check element to make sure it is seated properly on element
base or sealing surface.
Figure C.5.1: Weather hood and wing nut in secured position.