Solberg MiniPFS(Pg.2-5) - Manual (Page 8)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 8
If you are not confident that the integrity of the element was maintained during
cleaning, it is recommended that a new element be installed. Also, spare parts
such as gaskets, wing nuts and washers can be supplied upon request.
Section C
PROCEDURES
1. Installation.
A. Maximum operating temperature for most Solberg inlet air filter products is
220°F / 105°C. Temperatures in excess of this could cause damage to
elements, media and elastomers. High temperature products are
available.
B. Direction of flow is typically from the outside of the element to the inside of
the element. Most products have arrows indicating direction of flow on the
inlet and outlet ports.
C. Ensure that pipe/flange connections are adequately sealed so the
potential for leaks is reduced to a minimum.
2. Disconnecting canister top from canister base.
PS-(02, 03, 04, 05, 06, 07, 10, or 11): Lift top housing tabs to open. Use
care to support bottom housing while removing top housing. Release all
tabs and lift off housing top from base.
Figure C.1: Housing Terms