Solberg MiniPFS(Pg.2-5) - Manual (Page 10)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 10
*WARNING*
Failure to comply with these instructions
may result in system or equipment
contamination.
4. Securing Element.
Place new or cleaned element evenly in housing base. The wider end of
the element should be in line with the closing seam of the housing. Be
sure element seats properly in the housing base and there is no dirt or
particulate present on sealing surfaces. See Figure C.3.1.
*WARNING*
Defective installation may cause system or
pump contamination. Use only genuine
Solberg replacement parts.
5. Securing canister top to canister base.
A. Make sure all surfaces are free from dust and other particulate.
B. PS-(02, 03, 04, 05, 06, 07, 10, or 11): Reassemble housing top to base by
aligning tabs and pressing housing top down onto base. Tabs should snap
into place, see Figure C.5.3. Housing top securing position varies
depending on if the canister includes an element. See Figure C.5.1 if an
element is inside of the housing and Figure C.5.2 if an element is not
included.
Figure C.5.1: Canister securing position
for housing with elements. Figure C.5.2: Canister securing position
for housing without elements.