Clarion DPX1001.2 User Manual

Page 12

DPX1001.2 Power System Amplifier

SETTING THE GAIN
After completing the installation, follow these steps to set the Gain Control
and then perform the Final System Checks.

1. Turn the Gain Control all the way counter-clockwise.

2. Turn the vehicle’s Ignition Switch to the ON position. Then turn the
ON/OFF Switch on the source units to the ON position. Set all Tone or
Equalization Controls to “flat” positions and turn Loudness off.

NOTE: If the system uses an equalizer, set its frequency controls to “flat”

positions.

3. Play a CD or Tape and set the Volume Control at 75% of full level.

4. Slowly increase the Gain Control. Stop when you hear a slight distortion of
audio.

SETTING THE CROSSOVER
The Clarion DPX1001.2 features a fully adjustable crossover. To set the
crossover, follow these steps.

1. Using the Amp Mode Switch, select the desired mode - Low Pass or Full
Range.

NOTE: Fullrange selection will disable x-over adjustments.

2. Using the Freq (Hz) Control, select the desired frequency.

SETTING THE BASS BOOST
1. Initially set the Bass Boost control to its full left position (i.e. 0dB).

2. Listen to a variety of music styles (e.g. Rock, Rap, etc.) and slowly
increase the Bass Boost control until a noticeable increase in low bass
response is perceived.

3. Slowly adjust the Bass Boost control (up or down) to realize the best bass
response.

CAUTION: If you hear a “pop” (due to speaker over-excursion), lower the

Bass Boost to prevent speaker damage. If the system sounds muddy and dis-

torted (due to amplifier clipping), lower Bass Boost to avoid shutdown from

overheating.