Shellab SGO5-2 - Manual (Page 9)

9
values between 0 and 5 to be set (digit 3).
C. One Minute Function: After the correct ten minutes value is set, push the RESET pad
again. The blinking decimal point will move one digit to the right beyond digit 4 and be
located at the extreme bottom right of the display. With the display in this mode, pushing the
UP or DOWN arrow pad will increase or decrease the one minute function allowing the
value of digit 4 to be adjusted between 0 and 9.
D. Activation: Pause until the timer stops blinking. After all settings are made, push the
START/STOP button. The Timer Activated light will come on and after a brief pause, the
present oven temperature settings will be valid and heating will begin. The oven will now
heat up, control at the set point and stop after the timed period on the SET/TIMER display
has elapsed.
Note that when the system is in the timer mode, the heating circuit is de-energized until the START/STOP
button is pushed or the TIMER SWITCH is turned Off. If a time change or correction is necessary and the
timer has already been activated, push the START/STOP button to "STOP" the timer, then repeat steps A
through D above.
6.7 To set the timer so that timed operation will not start until the oven is stable at set point, pre-heat the
oven in the normal mode until the desired temperature has stabilized. Turn on the timer switch.
Push and hold the RESET button until the timer display blinks. (This is to be sure that the pre-set
timed value is correct). Press the START/STOP button to activate the timer.