Shellab SGO5-2 - Manual (Page 10)

10
MAINTENANCE
Note: Disconnect the power cord from the power source before performing any
service or maintenance on this unit.
7.1 Cleaning: Cleaning and decontamination are recommended on a regular basis.
To prepare the unit for cleaning, remove all interior parts if assembled, such as
shelves and shelf clips.
First clean the chamber with soap and water, rinse and let dry. To decontaminate
use a solution that is appropriate for your application. DO NOT USE chlorine-
based bleaches or abrasives as this can damage the stainless steel components.
DO NOT USE spray cleaners that might leak through openings and cracks and get
on electrical parts or that may contain solvents that will harm the coatings.
WARNING: Never clean the unit with alcohol or flammable cleaners with the unit
connected to the electrical supply. Always disconnect the unit from the electrical
service when cleaning and assure all volatile or flammable cleaners are
evaporated and dry before reattaching the unit to the power supply.
7.2 Use care when cleaning the door gasket to prevent damage which could impair the
positive door seal.
7.3 STORAGE: To prepare the unit for storage, remove all shelves and shelf clips
and disconnect the power supply. Be certain that the chamber is completely dry
and door is positively locked in the closed position. See Section 3.3,
Lifting/Handling, for proper transport procedures.
7.4 No maintenance is required on the electrical components. If the unit fails to operate
as specified, please see the Troubleshooting guide, Section 8.0, before calling for
service.
Section
7