Seville Classics UHD16241 - Manual (Page 10)

Step 8: Install (#8, #9 and #10) Back Panels.
Step 9: Install (#6) Leveling Feet.
Note:
Step 10: Install (#15, #16 and #17) Corner Protections.
1). Attach (#15, #16) Corner Protection A, B onto
Top and Bottom of the cabinet, use 20pcs (#54)
Screw N to tighten.
2). Attach (#17) Middle Corner Protection to the
middle of (#1-A) Left Side Panel and (#2-A) Right
Side Panel, use 8pcs (#54) Screw N to tighten.
Wheels are not included with this unit, however
there are 4 screw holes built into (#4) Bottom Panel
for installation. Wheels can be purchased at
www.SevilleClassics.com
ASSEMBLY INSTRUCTIONS
(pg 9 of 11)
Storage Cabinet (Model No. 16241)
1). Attach (#10) Bottom Back Panel onto both
Bottom of Left and Right Side Panels (#1-A2 and #2-
A2) and Bottom Panel (#4), line up screw holes, use
15pcs (#41) Screw F to tighten.
2). Attach both (#9) Middle Back Panel above (#10)
Bottom Back Panel the same way. Place the groove
of the (#9) Middle Back Panel onto the top edge of
the (#10) Bottom Back Panel, use 18pcs (#41)
Screw F to tighten.
3). Use 18pcs (#41) Screw F to install (#8) Upper
Back Panel the same way.
Attach (#6) Leveling Feet to the four side corner of
(#4) Bottom Panel, use (#25) Wrench to tighten.
Rotate/Stand Storage Cabinet upright after this step.