Seville Classics FRN04737 - Manual (Page 2)

Please make sure you have all the parts before assembly
A 1 pc B 10 pcs C 4 pcs
Wine Rack Long Screws Short Screws
(pre-inserted in the unit)
Step 1:
Use a Phillips screwdriver to loosen the
10 Long Screws (B) that have already
been pre-inserted in the unit. Do NOT
remove the screws from the unit. Simply
loosen them to carefully unfold the unit.
NOTE: Do NOT place the unit vertically
when unfolding as this may result in the
unit suddenly unfolding and pinching your
fingers. Find a flat surface to assemble
the unit. Using an uneven surface to
assemble the unit may result in uneven
shelves. If the unit is uneven after
assembled, loosen all the screws, adjust
the unit and then retighten all the screws.
Step 2:
First, tighten the 10 pre-inserted long
screws. Next, screw-in and tighten the 4
Short Screws (C) into the 4 screw holes
on the unit. Do NOT over tighten the
screws.
How to Fold the Wine Rack (If Needed):
First, fully loosen and remove all 4 short screws from the unit. Next,
fully loosen, but do NOT remove, the 10 remaining pre-inserted long
screws. Finally, carefully fold down the unit. Please note that the unit
CANNOT be folded completely flat. Forcing the unit into a folded
position without first removing the 4 short screws and fully loosening the
10 pre-inserted long screws may result in irreparable damage to the unit.
CAUTION:
Do NOT place the unit in high temperature area or near appliances that
emit large amount of heat.
Do NOT place the unit outdoor, as exposure to direct sunlight may
cause the color to fade.
Do NOT place the unit on uneven surfaces. Doing so may cause the unit
to tip over.
Examine the screws periodically and tighten them if they are loose.