Seville Classics FRN04714 User Manual

Page 4

Step 2: Use screws (E) to install the wooden rack (A) onto

wooden leg (B). Use hex key (F) to tighten the screws.

You can also insert the hex drill bit (K) into a power drill to

tighten the screws.

Step 1: Fasten leveling foot (H) onto wooden leg (B).

Tools required: screw driver, power drill , drill bit (1/8") .

ASSEMBLY INSTRUCTIONS (page 3 of 6)

Step 3: Move the wine rack to the desirable place. Fasten the safety

strap (I) onto wine rack. Fasten another side of safety strap onto

the wall. To secure the wine rack, you can use a stud finder or

knock the wall to locate the stud inside of the wall. Please note the

interval between two studs is normally 16" (center to center).

Locate the stud nearest to the wine rack and find the center of stud.

Use pencil to mark the center of the stud and thread the screw (J)

through washer (C) and the eye of metal chain into the center of

stud.

If you can not find the stud inside of the wall near wine rack,

you need to install the plastic anchor (D) onto the dry wall before

fasten the screw (J).

Use power drill to drill a hole on the dry wall.

Then install the plastic anchor into the dry wall.Thread the

screw (J) through washer (D) and the eye of safety strap into the

hole of plastic anchor.