Seville Classics SHE15894B - Manual (Page 2)

A B C D E
Side Frame (x2) Leveling Foot (x4) Cap (x4) Shelf (x2) Stacking Pin (x4)
STEPS TO ASSEMBLE THE RACK
1. Unpack and remove all parts from the box. If there
are missing or broken parts, please contact CUSTOMER
SERVICE.
2. Screw the LEVELING FEET (B) into the legs of each
SIDE FRAME (A). Insert the CAPS (C) into the top holes
of each side frame.
3. Lean one side frame against a non-scratchable
surface (e.g., a wall) and insert the hooks on both sides
of the SHELF (D) into the lower brackets of the side
frames. It's easier to attach the bottom shelf first
especially if you keep one of the side frames pressed
firmly against a non-scratchable surface (e.g., a wall).
4. While keeping one side frame pressed firmly against
a non-scratchable surface (e.g., a wall), repeat step 3 for
the second (top) shelf.
5. Ensure the hooks on both shelves are firmly inserted
into both side frames. Once all shelves are securely in
place, adjust the leveling feet by screwing them in or
out to obtain a level rack.
STEPS TO
1. Build another rack following the instructions above.
However, do not install the LEVELING FEET (B) on the
second (top) unit.
2. Screw the STACKING PINS (E) into the legs of the top
unit. Remove all CAPS (C) from the original (base) unit.
3. Lift the top unit up and onto the base unit, lining up
the pins with the holes at the four top corners so that
they can be inserted into each other. Be sure everything
is in alignment and then press down firmly on the top
unit so that it fits tightly into and onto the base unit.
STACK THE RACK
2 Units - 2 Configuration Options
3 Units - 3 Configuration Options
NOTE: Drawing shows 2 units
stacked vertically. Do not exceed
maximum height of 2 stacked units.
Building a modular shelving system, horizontally interlock
multiple units by attaching the shelves to the side frames of
corresponding units.
Scan code or visit link to view an assembly video:
youtu.be/Nyc05rL2iyw