Santec 9562KT User Manual
Page 3
0 3
9560,9561,9562 KL, KR, KT _ _
To w e l B a r
Remove the Mounting Hardware Post from the Bar Posts and use them
as references for positioning. Make sure that the Bar is level and the
Bar Post positions are correct.
Mark the four screw hole positions by using the Mounting Hardware
Post.
Using a drill, pre-drill holes for the Toggles.
Fold the Toggle’s leg and insert it into the wall.
The Mounting Hardware Posts can be secured by screwing the Screws
into the Toggles.
For wooden surface, the Mounting Hardware Posts can be secured by
screwing the Screws directly into the wall.
Installing On Dr ywall
Installing On Wooden Surface