Santec 9529KT-TM - Manual (Page 6)

0 6
9527/9529KL, KR, KT _ _
Step 1- Take the plastic guard off the valve.
Step 2- Thread the bonnet nut, all thread and stem key onto the valve
and lightly tighten assembly with a 1” plumber’s socket wrench. See
Diagram A on next page.
Step 3- Make a mark on the all thread that is a maximum distance from
Step 4- Un-thread the bonnet nut, all thread and stem key from the
valve and remove the stem key only from the rest of the assembly.
Step 5- Using a hacksaw, cut the excess at the mark on the all thread.
Re-insert the stem key into the assembly. From the end of the newly cut
all thread measure a distance of 1/2” on the stem key and make a
mark. Cut the excess at the mark on the stem key. See Diagram B on
next page.
Step 6- Re-thread the bonnet nut, all thread and stem key back onto the
valve and snugly tighten assembly with a 1” plumber’s socket wrench.
See Diagram B .
Trim Installation (1)
H a n d l e T r i m
2-1/2” - 3”
Backset Finished Wall
1-1/4“
Past
Finish
Wall
All Thread
Bonnet Nut
Stem Key
Finished Wall
1/2”
Stem Key Past
All Thread
D i a g r a m A
D i a g r a m B
Maximum