Va l v e, Valve installation (1) – Santec 9529KT-TM User Manual
Page 3
0 3
9527/9529KL, KR, KT _ _
Va l v e
Valve Installation (1)
for extra thickness dimensions when roughing in the valves.
necessar y to accurately plumb in the valve.
Install the valve with the plastic guard into the wall making sure that
the measurement between the center of the valve inlet and the outside
called the backset. See next page for backset measurements on all
handles.
NOTE: Hole size for the spout and handles are minimum of 1-5/8”
and maximum of 1-3/4”.
2-1/2” - 3”
Backset
Finished Wall
WARNING: Keep the plastic guard on the top of the valve at ALL times
to prevent any damages to the valve or cartridge. Failure to do so will
void the warranty of the valve.
Center of Valve Inlet
Min/max