Santec 9255DC User Manual
Keep this instruction booklet for future reference, Page 01
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
MINIMUM HOLE SIZE FOR THE SPOUT AND
HANDLE TRIM IS 1
¼
” AND MAXIMUM OF 1
½
”
*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.
BAROQUE & ENZO APPLICATION
EDO APPLICATION
¾” N.P.T. SPOUT SHANK
QUICK CONNECT SHANK
-Remove tee connector and spout mounting
-Remove tee connector and spout
hardware from spout nipple.
mounting hardware from quick
-Apply a ring of silicone caulking around
connect shank being sure to leave
hole designated for spout
.
on brass plate.
DO NOT USE PLUMBERS’ PUT TY, WHICH
-Apply a ring of silicone caulking
CAN DAMAGE FINISH.
around hole designated for s
pout.
-Slip spout and spout base throu
gh top of
DO NOT USE PLUMBERS’ PUTTY,
deck.
WHICH CAN DAMAGE FINISH.
-Reattach spout mounting hardware and
-Slip quick connect shank through
secure spout.
deck top.
-Thread tee connector onto spou
t shank.
-Reattach spout mounting hardware
until secure.
-Place spout onto quick conn
ect
shank and set in place with allen key
and set screw provided.
Large Allen Key
ROMAN TUBS W & W.O. HANDSHOWER INSTALLATION
INSTRUCTIONS FOR DROP IN VALVES