Santec 6920MG - Manual (Page 2)

0 3 0 4
HANDLE TRIMS ARE READY FOR SIMPLE DROP-IN INSTALLATION. DO NOT DISASSEMBLE.
H a n d l e
Handle Installation
Remove the valve body mounting hardware from the
valve body.
Make sure the handle with the “cold” blue label is
installed at the right side of the spout (looking from front)
and the handle with the “hot” red label at the left side of
the spout.
Apply a ring of silicone caulking around the handle hole
on the sink or counter top (do not use plumber’s putty
which can damage the finish of your faucet).
Slip the valve body’s flexible hoses from the top of the sink or counter through the appropriate hole
next to the spout. Aim the tee connecting hoses toward the tee connector.
Rubber washer
Fiber washer
Brass lock nut
A
Align the handle lever properly with respect to the spout.
From under the basin or counter, hand tighten the brass
lock nut and fiber washer to the valve body against the
counter.
B
Secure the valve body by tightening the screws
attached to the lock nuts.
C
SANTEC
SANTEC
SANTEC
H a n d l e
Handle Installation
Loop and connect the flexible hoses to the tee.
Tighten the nuts provided at the of the hose to avoid
leakage.
Connect and tighten the Inlet hoses to the supply lines.
Use 1/2” IPS faucet connections, or 3/8” copper piper
using compression fitting system.
D
Water supply
line
Water supply
line
SANTEC
INLET HOSE INLET HOSE