Santec 5620MO - Manual (Page 4)

Page 04
Drain Plug
Drain Flange
Lift Rod Strap
Ball Rod
Drain Tube
Ball Rod Nut
Ball Rod Clip
Thumb Screw
Lock Nut
Washer
Gasket
Side hole
Lift Rod
INSTALLATION INSTRUCTION
POP-UP DRAIN INSTALLATION
1. Remove decorative drain flange and drain plug from pop-up assembly.
2. Apply a ring of silicone caulking to underside of decorative drain flange.
DO NOT USE PLUMBERS’ PUTTY, WHICH CAN DAMAGE FINISH.
3. Insert threaded end of the assembly up from below sink
4. Completely thread drain body into decorative drain flange and align with ball
rod hole facing back and tighten lock nut from below.
5. Insert drain plug into decorative drain flange with adjustable eye-screw
facing back.
6. Attach ball rod washer and ball rod nut to horizontal ball rod and install
into drain body.
7. Do not over tighten. Ball rod must operate freely.
8. Slide lift rod and knob through spout and from below the lift rod strap
and tighten thumbscrew.
9. Gently push the horizontal ball rod down to place the drain plug in the
up position.
10. Slip one leg of ball rod clip off horizontal rod and insert lift rod strap,
reattach leg of ball rod clip.
11. Test pop-up for smooth operation and adjust if necessary.
F LUSH T HE L INE
• After all connections have been made from inlet supplies to angle stop, remove the aerator.
• Open both hot and cold valves.
• Slowly open angle stop from below and flush the lines for approximately 45 seconds to clean any debris.
• Turn off the water and reinsert aerator.
COLLECTION
WIDESPREADS