Santec 5620MO - Manual (Page 3)

Page 03
INSTALLATION INSTRUCTIONS
H ANDLE T RIM I NSTALLATION
HANDLE TRIMS ARE READY FOR DROP IN INSTALLATION. DO NOT DISASSEMBLE.
Step 1
Remove the valve body mounting hardware
from the valve body.
Hot valve assembly “Red” to be mounted on
left.
Cold valve assembly “Blue” to be mounted on
right.
Step 3
Align handle with respect to the spout and
tighten valve body locknut until secure.
Make sure the correct open/close position was
installed.
Step 2
Apply a ring of silicone caulking around the
handle hole on the sink countertop.
DO NOT USE PLUMBERS’ PUTTY WHICH CAN
DAMAGE FINISH.
Slip valve through appropriate hole in sink or
countertop.
Step 4
Snug bottom locknut security screw.
Aim outlet hoses towards tee connector and
attach securely to avoid leakage.
mounting
hardware
Fiber washer
Brass lock nut
COLLECTION
WIDESPREADS
Valve
extension
STOP! FLUSH THE LINE!*
•
•
•
•
•
•
•
•
•
•
rubber washer
*
F LUSH T HE L INE
After all connections have been made from inlet supplies to
angle stop, open both hot and cold valves.
Slowly open angle stop from below and flush the lines for
approximately 45 seconds to clean any debris.
Turn off the water
Flow
Restrictor
•
•
•