Santec 4350PR - Manual (Page 3)

INSTALLATION INSTRUCTIONS
PAGE 03
HOT WATER
SUPPLY
COLD WATER
SUPPLY
Cold Valve Hot Valve
2
- Position the valve body side outlet towards the tee connector (18) for easier pipe
connection.
- Align the handle lever properly with respect to the spout and tighten the lower lock
nut (11) firmly.
- Repeat the same procedure for the opposite side.
- Connect the water supply lines to the bottom inlets of the valve bodies. **
- Connect the valve body side outlet to the tee connector (18). **
** The spout, handle valve bodies and tee connector can be connected with flex hoses (not provide by Santec) or copper pipe
soldering. Please note that when soldering connections, do not use excessive heat. Excessive heat can damage the valve
body joints thus increasing possibility of leakage.
WATER TEST
- Turn on the cold water supply.
- Use the handle from the faucet set to turn the valve on and off.
- Check for leaks. If water leaks from any of the connections merely tighten the connections until the leak stops.
- Repeat the same procedure for the hot side
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
07/04
4350PR _ _