Santec 4150BL-TM - Manual (Page 4)

PAGE 04
4150BL _ _-TM
SANTEC LIFETIME LIMITED WARRANTY
1. Finishes: Santec Polished Chrome, Polished Orobrass and Satin Nickel finishes carry a Lifetime
Limited warranty against manufacturing defects and tarnish to the original purchaser with the
exclusion of kitchen drain assemblies which, due to the nature of their use, are not warranted. Santec
recommended custom finishes carry a ten (10) years limited warranty against manufacturing
defects and tarnish to the original purchaser with the exclusion of kitchen and pop - up drain
assemblies which, due to the nature of their use, are not warranted.
2. Cartridges: Santec Cartridges carry a lifetime limited warranty against manufacturing defects for the
life of the product to the original purchaser.
3. Parts: Santec parts carry a Ten (10) year limited warranty against manufacturing defects, to the
original purchaser.
4. Warranty exclusions and limitations : This warranty does not cover: damage due to negligence,
accident, abuse, improper installation, or improper maintenance such as, but not limited to: heat from
soldering during installation, the use of plumbers putty, damage from tools used during installation,
the use or exposure to chemicals or cleaning products either abrasive or non abrasive or the use of
any cleaning tool or product other than a soft, clean cloth. This warranty does not cover: changes in
the finish or in the product due to normal wear or aging and does not cover any product or parts
which have been altered or used in a manner not typical for the product. This warranty does not
cover and Santec will not be held liable for damage to products caused by the freight carrier
and a claim should be made immediately to the freight carrier should this occur. This warranty
does not cover any cost involved in the installation, repair, or replace ment of any Santec product or
part. This warranty does not cover and Santec will not be held liable for any loss, damages, or
expenses, incidental or consequential whatsoever, originating from the purchase, installation, use,
repair, failure, or replacement of any Santec product or part, as allowed by law. The product or
components of the covered product will either be repaired, refinished or replaced, at the sole
discretion of Santec. Santec reserves the right to examine any product claimed defective pr ior to
any warranty claim being accepted or processed, at its sole discretion. This warranty gives you
specific legal rights and you may have other rights which may vary from state to state.
Effective 10/01/03 - Replaces and supersedes any previously issued warranty.
FINISH CARE INFORMATION
For clear coated or enamel color finishes:
We recommend that all faucets, drains, etc. Be gently wiped
dry with a soft cloth after use to avoid water spotting and
water deposit buidup. A mild liquid hand soap, such as Ivory
may be used if desired. Use of a non abrasive canauba wax
will add protection to the finish and should be used if the
faucet will not be dried after use. Santec Orobrass kitchen
products are clear coated.
For non -clear coat ed and specialty finishes:
We recommend that all faucets, drains, etc. be
gently wiped dry with a soft cloth after use to avoid
water spotting and water deposit buildup. Use of a
non -abrasive carnauba wax is required
occasionally.
Santec has obtained applicable code (standards) listings generally available on a national basis for products of this type.
It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the product.
Santec makes no representation or warranty regarding, and will not be responsiblefor any code compliance.
Some products listed in this catalog may not be approved for use in the state of Massachusetts, check with your Local Authority
or Licensed Plumber to assure code compliance.
Lead Precaution Information:
Most sources of drinking water contain some
amounts of lead. Brass faucets, fittings, water meters
etc. can create small amounts of lead if the water
is allowed to stagnant in them for an extended period
of time. We suggest that you ALWAYS RUN WATER
FOR A SECOND OR TWO TO CLEAR THE FAUCET
OF STANDING WATER PRIOR TO USE. This simple
procedure will prevent detectable amounts of lead from
the faucet entering into the water you consume.
Due to the fact that brass faucets can facilitate allowing
detectable amounts of lead into the water, when it is
allowed to stand in them for some time, some
states like California mandate the following notice;
WARNING: ALL BRASS FAUCETS CONTRIBUTE
DETECTABLE AMOUNTS OF LEAD, A CHEMICAL
KNOWN TO CAUSE BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM.