Santec 4150BL-TM - Manual (Page 2)

1
.
ROUGH INSTALLATION
DO NOT REMOVE THE SPOUT PROTECTANT HOOD PRIOR TO TRIM INSTALLATION
A
- Install P0285 roman tub rough prior to installing the trims.
(Roughs are sold separately).
2.
SPOUT INSTALLATION
A
- Remove the faucet from the box.
- From the top of the deck, insert the spout (1) and flange (2) onto the top
of quick connect shank.
- Align the spout and tighten the set screw (7) with the Large Allen Key (9).
Insert the spout plug (10) into the spout back hole.
Note: for better installation it is advisable to place silicone caulking around all holes
on the top of the deck
3.
HANDLE TRIM INSTALLATION
A
- S crew the handle trim (6) onto the upper lock nut of installed valve.
- Adjust the handle alignment in respect to the spout.
- Make sure that the handle turns freely in both direction and tighten
the brass lock nut firmly. If the handle is scraping against the stem,
lower the valve body to reduce the friction.
- Repeat the same procedure for the oppose side handle.
PAGE 02
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
AFTER FLUSHING, SHUT OFF BOTH SUPPLY LINES
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4 ” AND MAXIMUM IS 1 1/2 ”
INSTALLATION INSTRUCTIONS
Metal washer
Brass lock nut
Upper Lock Nut
Fiber Washer
Brass lock nut
rubber washer
HOT WATER
SUPPLY HOT WATER
SUPPLY COLD WATER
SUPPLY COLD WATER
SUPPLY
Cold Valve Cold Valve Hot Valve Hot Valve
4150BL _ _-TM
A
A
A