Santec 3620EN - Manual (Page 2)

INSTALLATION INSTRUCTIONS
HANDLE TRIM INSTALLATION
HANDLE TRIMS ARE READY FOR DROP IN INSTALLATION.
DO NOT DISASSEMBLE.
Remove the valve body mounting hardware from the valve body.
Hot valve assembly “Red” to be mounted on left.
Cold valve assembly “Blue” to be mounted on right.
-Apply a ring of silicone caulking around the handle hole on the sink
countertop.
Slip valve through appropriate hole in sink or countertop.
Align handle with respect to the spout and tighten valve body locknut
until secure. Aim outlet hoses towards tee connector and attach securely
to avoid leakage.
PAGE 02
POP-UP DRAIN INSTALLATION
A- Remove decorative drain flange and drain plug from pop-up assembly. Apply a ring of silicone
caulking to underside of decorative drain flange. DO NOT USE PLUMBERS’ PUTTY, WHICH CAN
DAMAGE FINISH. Insert threaded end of the assembly up from below sink. Completely thread
drain body into decorative drain flange and align with ball rod hole facing back and tighten lock
nut from below. Insert drain plug into decorative drain flange with adjustable eye-screw facing back.
Attach ball rod washer and ball rod nut to horizontal ball rod and install into drain body. Do not over
tighten, bal rod must operate freely. Slide lift rod and knob through spout and from below the lift rod
strap and tighten thumbscrew. Gently push the horizontal ball rod down to place the drain plug in the up
position. Slip one leg of ball rod clip off horizontal ball rod and insert lift rod strap, reattach leg of ball
rod clip.
- Test pop-up for smooth operation and adjust if necessary.
Drain Plug
Drain Flange
Lift Rod Strap
Ball Rod
Drain Tube
Ball Rod Nut
Ball Rod Clip
Thumb Screw
Lock Nut
Washer
Gasket
Side hole
Lift Rod
FLUSH THE LINE
After all the connections have been made from inlet supplies to angle stop, remove the aerator. Open both hot and cold valves. Slowly open angle
stop from below and flush the lines for approximately 45 seconds to clean any debris. Turn off the water and reinsert aerator.
WIDESPREADS
COLLECTION
SANTEC SANTEC
rubber washer
SANTEC SANTEC
Fiber washer Fiber washer
Brass lock nut Brass lock nut
DO NOT USE PLUMBERS' PUTTY WHICH CAN DAMAGE FINISH