Santec 3524TX - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4 ” AND MAXIMUM OF 1 1/2 ”
SPOUT INSTALLATION
1
- Insert the Rubber O rings in to the shank. And put the complete bridge assembly (1)
aligning two holes on the deck holes, which are 4 inches apart.
Put in the rubber washers (PM-400) in the groove provided under the flanges.
Apply a ring of silicon caulking around the center hole on the top of the sink. Do not use
plumbers' putty which can damage the finish of the faucet.
2
- Slip the rubber washer from the mounting hardware supply onto the shank under the deck.
After that slip on metal crimped washer on the shank and lastly the brass lock nut.
- Align the spout and tighten the shank lock nuts firmly. Tighten to seal.
PAGE 02
3524 TX _ _