Santec 2680EK - Manual (Page 3)

Drain Plug
Drain Flange
Lift Rod Strap
Ball Rod
Drain Tube
Ball Rod Nut
Ball Rod Clip
Thumb Screw
Lock Nut
Washer
Gasket
Side hole
Lift Rod
P OP- U P D RAIN I NSTALLATION
1. Remove decorative drain flange and drain plug from pop-up assembly.
2. Apply a ring of silicone caulking to underside of decorative drain flange.
DO NOT USE PLUMBERS’ PUTTY, WHICH CAN DAMAGE FINISH.
3. Insert threaded end of the assembly up from below sink.
4. Completely thread drain body into decorative drain flange and align with
ball rod hole facing back and tighten lock nut from below.
5. Insert drain plug into decorative drain flange with adjustable eye-
screw facing back.
6. Attach ball rod washer and ball rod nut to horizontal ball rod and
install into drain body.
7. Do not over tighten. Ball rod must operate freely.
8. Slide lift rod and knob through spout and from below the lift rod
strap and tighten thumbscrew.
9. Gently push the horizontal ball rod down to place the drain plug in
the up position.
10. Slip one leg of ball rod clip off horizontal rod and insert lift rod strap,
re-attach leg of ball rod clip.
11. Test pop-up for smooth operation and adjust if necessary.
INSTALLATION INSTRUCTIONS
PAGE 03
SINGLE CONTROL LAV SET
COLLECTION