Santec 2680EK - Manual (Page 2)

S POUT I NSTALLATION
Step 1
·
Remove lock nut, metal washer and
rubber washer from mounting rods.
· Insert the lift rod into the fixture.
Step 3
·
Re-install rubber gasket and metal washer
from below.
· Hand tighten lock nut from below while
aligning fixture.
Step 2
·
Apply a ring of silicone caulking around
hole designated for spout.
DO NOT USE PLUMBERS’ PUTTY WHICH
CAN DAMAGE FINISH.
·
Insert faucet assembly through hole in sink
or counter top, being sure to center faucet
in hole.
Step 4
·
Secure fixture from below by using either
an adjustable wrench,
basin wrench or
deep socket to the lock nut.
· Connect fixture to water supplies.
NOTE (
F LUSH T HE L INE):
After all the connections have been made from inlet supplies to angle stop, remove the aerator.
Open both hot and cold valves. Slowly open angle stop from below and flush the lines for
approximately 45 seconds to clean any debris. Turn off the water and reinsert aerator. Debris
present in the line will damage fixture and cause leaking. Failure to flush fixture could result in
possibly voiding warranty.
INSTALLATION INSTRUCTIONS
PAGE 02
SINGLE CONTROL LAV SET
COLLECTION
rubber washer
metal washer
lock nut
Lift rod
SIL
IC
ON
E