Santec 2027XL - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 3/4”
INSTALLATION INSTRUCTION
INSTALLING THE VALVE WITHOUT THE TRIM
1- If the valve is installed first without the trim, please leave
2-1/2” to 2-3/4” space between the center of the inlet and the
finished wall. This will leave enough thread length to be
adjusted when the trim is installed.
WARNING: Where tile construction is planned for the
finished walls, allow for the extra thickness
dimensions when roughing in the valves.
INSTALLING THE VALVE WITH THE TRIM
1- Install the valve onto the wall with 2-1/2” space
between the center of the valve inlet and the
finished wall.
2- Screw the handle bell with the flange and washer onto
the all thread, press them firmly against the wall.
Mark position, remove the bell and cut off excess thread.
Reinsert the handle bell onto the all thread and press all
parts firmly against the wall.
PAGE 02
center of IN port
finished wall
4” ~ 4 1/8 ”
ALL THREAD
STEM
ALL THREAD
STEM
2027XL _ _
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE SCREW BUTTON CAP