Reliable T3 - Manual (Page 12)

12
PROBLEM
LED is not on
No steam
Pale residue left on the floor
(caused by leaving the floor
steamer in the same position
for too long)
Too much water on the floor
No steam comes out
REMEDY
1. Ensure Steamer power cord is correctly plugged into
power outlet.
2. Ensure circuit breaker is operational.
3. Try operating the steamer from another power outlet.
1. Ensure the water tank has correct level of water.
1. Can be removed with household white vinegar
or a decalcifying product.
2. Alternatively reheat the area for one minute and residue
should be removed. CAUTION: DO NOT OVERHEAT AREA.
1. Hold steam switch for no longer than 5 seconds at a time.
Release the switch for a few seconds and then you can
repeat (the heating element needs time to heat up again to
properly convert the water into steam.
1. Have you pressed the steam release button correctly?
2. The Steamboy PRO T3 is not yet ready to operate. Hold the
steam release button down for approx. 30 seconds until you
no longer hear any pumping noises and the device begins to
emit steam.
3. The water tank is empty. Fill it up.
TROUBLESHOOTING
CAUTION: Prior to troubleshooting isolate the unit by removing the cord
from the power socket.